Combi shell mill holder SK 30 - 22 - 35Application: For mounting milling cutters with transverse or longitudinal groove. Delivery: With retaining screw, driving ring and feather key All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Standard type without safety clutch

To increase the specific contact pressure per unit area

bei Ø 6 – Ø 32 mm = h233

clamping depth = 58

5 mm less than nominal

If your 3D probe is nevertheless damaged by external force

DCONWS = 40 / DCONWS = 60:

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance6

Vorschub (Empfehlung): 1

slim design (reduced interference contour)

Resolution:

Extension rod