End mill holder Weldon SK 50 - 18 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- mobility allows measuring within machines and fixtures

set contains following adaptors:

Setting angle: 107

- Clamping accuracy at the centre 0

E3= 12 pieces

which prevents the breaking of taps

minimum and diviation

A complete certificate of calibration traceable to the N

The clamping screw is drilled through

load capacity 200kg

no adhesion occurs and the tool

For holding tapers according to DIN 69871